508723
29
Zoom out
Zoom in
Previous page
1/31
Next page
SPEED DOME CAMERA 

The dome
can be
controlled
but the
operation is
not smooth
1. The RS485 Bus line is
not in good contact with
the connectors.
2. One wire of the RS485
Bus is broken.
3. The dome is very far
away from controller.
4. There are too many
domes connected in the
system.
1. Secure the
connection.
2. Replace RS485 Bus
wires.
3. Add termination
resistors to the system.
4. Install RS485
distributor.
APPENDIX IV:
TROUBLE SHOOTING
Problem Cause Solution
No
movements,
no video
after power
on
Red LED on circuit board is off:
The is no AC power connected to
the PCB Board.
There is a power outage or problem
of the transformer.
Camera module is not correctly
connected.
Output Voltage of transformer is
too low.
The power board is not working.
Check the power
connection and outlet
make sure they are
working properly.
Check power supply and
transformer to see is they
are working properly.
Check all power related
cable.
Examine the power on the
dome side making sure it is
above 16 V.
Self-test is
ok but
dome can
not be
controlled
Wrong dip switch setting; Control
cable reversely connected or
disconnected
Set the dip switch
correctly according to
operation manual. Check
the control cable, making
sure it is correctly and
firmly connected.
Fan speed
under 1000
rps
Fan not firmly connected Connect fan correctly. If
speed is still under 1000
rpm, please contact dealer
to replace the fan
Blurred
picture
Dome in manual focus mode or
bubble is stained
Set focus to auto mode.
Clear the bubble
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SEC-CAM901 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SEC-CAM901 in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info