625968
191
Zoom out
Zoom in
Previous page
1/226
Next page
MAINTENANCE PROCEDURES
189
4.9.5.b CHANGING THE ENGINE OIL AND THE ENGINE OIL FILTER CARTRIDGE
WARNING
q Change the oil with the machine parked on a level surface and the work equipment resting on the
ground.
q Soon after the machine has been stopped the engine oil is very hot and may cause burns; let the engine
cool down until it reaches a temperature of 40÷45°C before draining the oil.
q The oil that may be spilled during the oil change will make the ground slippery: use anti-slip shoes and
immediately remove any trace of oil from the floor.
q Oils, filters, the coolant and the battery are considered special waste and must be collected and
disposed of according to the regulations in force.
Proceed as follows:
1. Open the engine hood (see "3.2.5 ENGINE HOOD").
2. Remove the drain plug (P) of the engine oil pan, gathering
the used oil that flows out of it into a container with suitable
capacity.
While the oil flows out, remove the filler cap (F), so that the oil
can flow out freely.
3. Screw the plug (P) onto the engine oil pan.
4. Using a filter wrench, unscrew the old filter (1) and reject it.
5. Clean the contact surface between the seal and the filter
support (2).
6. Lubricate the seal of the new filter and tighten until it rests
against the gasket.
7. Give another half turn by hand.
8.Fill the engine with the prescribed quantity of new oil, using the
dipstick (G) to check that the level reaches the MAX.
reference mark.
Use oil suitable for the ambient temperature (see "4.4 FUEL,
COOLANT AND LUBRICANTS").
9. Put back the filler cap (F), start the engine and stop it after 5
minutes.
Check the level again and top up, if necessary.
10. Close the engine hood.
Start the engine, make sure that there are no leakages and that
the engine oil pressure warning light goes out.
IMPORTANT
q Do not use the wrench to lock the filter, in order to avoid
damaging the filter itself and causing oil leakages.
191


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info