625968
192
Zoom out
Zoom in
Previous page
1/226
Next page
MAINTENANCE PROCEDURES
190
4.9.5.c CHANGING THE FUEL FILTER CARTRIDGE
WARNING
q Change the filtering element after work, when the engine has cooled down to 40÷45°C.
q During these operations some fuel may be spilled; clean the dirty areas immediately, in order to prevent
any risk of slipping or fire.
q Oils, filters, the coolant and the battery are considered special waste and must be collected and
disposed of according to the regulations in force.
FUEL FILTER
1. Open the engine hood.
(For details, see "3.2.5 ENGINE HOOD").
2. Turn the valve (1) of the filter to the closed position (A).
3. Using a filter wrench, loosen the metal ring of the filter and
remove the casing (2).
4. Clean the head of the filter holder and the inside of the
casing, install a new filter and fill the casing with fuel.
5. Lubricate the casing seal, install it on the filter holder and
tighten the metal ring until it touches the seal.
6. Give the metal ring a further 2/3 turn.
IMPORTANT
If the casing is tightened excessively, the seal may be
damaged and cause fuel leakages. Fuel leakages may also
be due to insufficient tightening. Therefore, it is advisable
to fix the casing by tightening the metal ring correctly.
BLEEDING THE FUEL CIRCUIT
WARNING
q The engine may start during the bleeding operations; make
sure that there is no one near the machine.
1. After filling the fuel tank, make sure that the valve (1) of the
filter is in open position (B).
3. Turn the ignition key to position ON and wait approximately
15-20 seconds, in such a way as to allow the fuel system to
be automatically bled.
3. Turn the ignition key to position START and start the engine.
IMPORTANT
q If the engine starts regularly and then stops or functions
irregularly, check if there is air in the circuit; in this case,
check the tightness of the fuel filter and of the fuel pump
prefilter.
q When all the fuel in the tank has run out, bleed the circuit
by proceeding as described above and repeat the
operation at least twice.
RKA14340
A
1
2
B
RYA17290
RYA17360
192


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info