625968
189
Zoom out
Zoom in
Previous page
1/226
Next page
MAINTENANCE PROCEDURES
187
4.9.5 MAINTENANCE EVERY 500 HOURS OF OPERATION
4.9.5.a LUBRICATION
IMPORTANT
q Clean the grease nipples before applying the greasing pump.
q After lubrication, remove all the contaminated grease that may have spread out of the nipples.
q If the machine is used in difficult conditions, carry out this operation more frequently than usual.
q As a general rule, it is important to consider that each cylinder is provided with two grease nipples
positioned on the couplings and that each pin serving as fulcrum point for a movement is provided with
at least one grease nipple.
q When running in a new machine, lubricate every 10 hours for the first 100 hours of operation.
LUBRICATING THE COMPONENTS OF THE SWING SYSTEM
NOTE
q When injecting grease to lubricate the swing pinion and the ball-bearing ring, swing the turret slowly and grease
every 90°
1. Carefully clean the grease nipples (1) and (2), and inject the
grease indicated in the lubricant chart using a grease pump
(see "4.4 FUEL, COOLANT AND LUBRICANTS").
2. After the operation, remove any trace of grease.
(1) Swing pinion (1 point)
(2) Ball-bearing ring (1 point)
LUBRICATING THE WORK EQUIPMENT
IMPORTANT
q After carrying out digging operations with the equipment immersed in water, always lubricate the pins
that have been in contact with water..
1. Position the machine as shown in the figure, lower the work
equipment to the ground and stop the engine.
2. Carefully clean the grease nipples listed below, and inject the
grease indicated in the lubricant chart using a grease pump
(see"4.4 FUEL, COOLANT AND LUBRICANTS").
3. After greasing, remove any trace of grease.
189


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Komatsu Galeo PC14R-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Komatsu Galeo PC14R-2 in the language / languages: English as an attachment in your email.

The manual is 6,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info