782826

Koenic KFK 45412 E NF Manual

23
Zoom out
Zoom in
Previous page
1/155
Next page
23
English
Bottom door
1 Hold the freezer door and remove the two
screws on the middle hinge.
2 Pull the freezer door upwards and place it on
a soft and clean surface.
3 Remove the blind cap above the freezer
compartment and the blind plug on the top
of the freezer door and insert them into the
holes on the opposite sides.
4 Unscrew the fitting on the bottom side
of the door. Use the additionally provided
fitting and install it on the opposite side.
Refrigerator bottom
Caution
Pull out the mains plug!
1 Tilt the refrigerator so you can work at the
bottom or place the refrigerator fully on its
back. Make sure the back is placed on a soft
and clean surface.
Unscrew the feet on both sides. Loosen the
screws and remove lower hinge plate.
2 Remove the door hinge bolt, turn the hinge
plate over and screw the door hinge pin in
the same hole from the other side.
3 Attach the turned hinge plate onto the
left side by screws. Screw the feet into the
plates on both sides.
Place the refrigerator back on its feet and
adjust them if necessary.
Mounting the door
Caution
After you have placed the refrigerator
upright on its feet, wait for at least 2 hours
before you connect it to the mains to permit
the cooling system to regain full capacity.
1 Place the freezer door on the lower hinge.
Turn the middle hinge and insert the bolt
into the left hole of the freezer door and
screw the hinge firmly. The freezer door is
now fixed. Check for correct function and
fitting.
2 Attach all previously removed parts to the
opposite side. Make sure that the cable is
properly stowed on the right side and is not
squeezed.
3 Place the hole provided on the left side of
the refrigerator door onto the bolt of the
middle hinge and hold the door firmly. Insert
the top hinge bolt into the left hole provided
on the top of the refrigerator door. Screw
the upper hinge plate to the refrigerator.
Check for correct function and fitting.
4 Connect the plug and socket. The plug must
snap into place.
5 Screw the cover cap onto the upper hinge
plate with the refrigerator door open.
6 Attach the cap of the left side to the right
side by screw.
Energy saving tips
• Do not place the product in the vicinity of a
heat source (radiator or kitchen stove, etc.).
• Ensure unobstructed air flow around the
refrigerator and freezer.
• If a layer of ice has built, defrost the unit. A
thick layer of ice aects the transmission of
the cold, thus the energy consumption will
be increased.
• When opening the door and taking out food,
only open the door shortly. A shorter door
opening time causes less ice to deposit on
the freezer walls.
IM_KFK 45412 E NF_201014_V10_HR.indb 23IM_KFK 45412 E NF_201014_V10_HR.indb 23 14/10/2020 5:26 PM14/10/2020 5:26 PM
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Koenic KFK 45412 E NF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Koenic KFK 45412 E NF in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish as an attachment in your email.

The manual is 6.42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info