772982
57
Zoom out
Zoom in
Previous page
1/82
Next page
MY20K10-02_1.0_10.11.2020 57
Cleaning and servicing
7.4 Maintenance
The following maintenance measures must be
performed on a regular basis.
7.4.1 Wheel
1Check the tyres for wear.
2Check the tyre pressure.
3Check the rims for wear.
The rims of a rim brake with invisible wear
indicator are worn as soon as the wear
indicator becomes visible in the area of the rim
joint.
The rims with visible wear indicator are worn as
soon as the black, all-round groove on the pad
friction surface is no longer visible. We
recommend that you also replace the rims with
every second brake lining replacement.
4Check the tension of the spokes.
7.4.1.1 Checking the tyres
Check the tyre wear. The tyre is worn if the
anti-puncture protection or the carcass cords
are visible.
A specialist dealer will need to change the tyre
if it is worn.
7.4.1.2 Checking the rims
Check the rims for wear. The rims are worn as
soon as the black, all-round groove on the pad
friction surface becomes invisible.
Contact your specialist dealer to have the rims
replaced. We recommend that you also replace
the rims at the same time as every second
brake lining replacement.
7.4.1.3 Checking and adjusting the tyre
pressure – Dunlop valve
Only applies to S pedelecs with this equipment
The tyre pressure cannot be
measured on the simple Dunlop
valve. The tyre pressure is
therefore measured in the filling
hose when pumping slowly with
the bicycle pump.
It is recommendable to use a
bicycle pump with a pressure
gauge. The operating instructions
for the bicycle pump must be
adhered to.
1Unscrew and remove the
valve cap. Connect the bicycle pump.
2Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
3Correct the tyre pressure according to
specifications in the S Pedelec pass.
4If the tyre pressure is too high, unfasten the
union nut, let air out and re-tighten the union
nut.
5Remove the bicycle pump.
6Screw the valve cap tight.
7Screw the rim nut gently against the rim with
the tips of your fingers.
Crash and falling caused by unintentional
activation
There is a risk of injury if the drive system is
activated unintentionally.
Remove the battery before maintenance.
Crash caused by braking hard on rims
A rim can break and block the wheel if you brake
hard. This may cause a crash with serious
injuries.
Check rim wear on a regular basis.
Notice
If the tyre pressure is too low in the tyre, the tyre
does not achieve its load bearing capacity. The
tyre is not stable and may come off the rim.
If the tyre pressure is too high, the tyre may burst.
Check the tyre pressure as per specifications.
Adjust the tyre pressure as necessary.
CAUTION
!
WARNING
!
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kettler Velossi 2.0 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kettler Velossi 2.0 in the language / languages: English as an attachment in your email.

The manual is 7.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kettler Velossi 2.0

Kettler Velossi 2.0 User Manual - German - 83 pages

Kettler Velossi 2.0 User Manual - Dutch - 82 pages

Kettler Velossi 2.0 User Manual - French - 84 pages

Kettler Velossi 2.0 User Manual - Spanish - 85 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info