686409

Kemppi A7 TIG Orbital System 300 Manual

28
Zoom out
Zoom in
Previous page
1/61
Next page
28
A7 TIG Orbital System 300© Kemppi Oy 2016 1615
OPERATING MANUAL
3.3.4 Compatible weld head models
The 300-series TIG orbital controller can use a 300-series
weld head. You can also use 150-series closed weld heads
with an adapter cable.
3.3.5 Calibrate head
To calibrate the weld head, press Menu in the Main menu
to enter the Maintenance menu. Once in the Calibrate
Head menu, do the following:
1. Select the model of the weld head to be calibrated.
2. Use Up/Down to navigate within the menu and
Enter to make a selection.
3. If this is the rst time calibrating a particular weld
head or you see “Calibration Out of Range” error
message, press Default after selecting the weld
head to install the factory setting for the correction
factor.
4. Select Travel Speed to calibrate.
5. For travel calibrations, choose the Distance to
Travel or Desired RPM by rotating the dial and press
Enter.
6. For wire calibrations, adjust the Amount to Run by
rotating the dial and press Enter.
7. Press Run and measure the actual amount traveled
or actual run time (or the length of wire).
8. Enter the measured value and press Save.
9. Repeat this process until you have achieved
desired accuracy, then press Back to return to the
Maintenance menu.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 TIG Orbital System 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 TIG Orbital System 300 in the language / languages: English as an attachment in your email.

The manual is 4,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info