686369
24
Zoom out
Zoom in
Previous page
1/66
Next page
24
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.14.2 Connect the second wire feeder
Connect the interconnection cable of the second wire feeder to the weld+ connector in
the front panel of the power source. Connect the control cable of the second wire feeder
to the extension connector in the back panel of the robot interface unit. Switch the power
source on and test the wire feeders by performing a wire feed test for both wire feeders.
Selecting the wire feeders from the setup panel or web user interface for the test.
In water-cooled systems with two water-cooled torches the cooling water circulation
must be equally distributed into both torches. It is recommended to connect the torches in
serial. In parallel the water ow can dier between the torches and may cause damage to the
torch. The extension kit includes support for water valves. Should you want to use valves to
control the circulation, please contact Kemppi service for instructions and guidance.
Only one wire feeder can be used for arc voltage measurement at the time. Do not
branch the arc measurement cables.
3.15 Powering up
Before powering up the welding system, check all cable connections.
Attach the power plug to an electrical socket, and switch the machine on. Check that
the machine starts up properly. The setup panel boots up within 10 seconds. The Web
UI is usually accessible in 30 seconds.
The Web UI access time depends greatly on the network conguration in use. The
fastest conguration is a direct connection with xed IP addresses. With a local area
network and DHCP, the access time can be signicantly longer.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info