686369
22
Zoom out
Zoom in
Previous page
1/66
Next page
22
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.14.1 Installation
Switch the power source o and install the extension kit into the robot interface unit.
Ensure that all the cables are installed properly. Test the system by switching the power
source on and selecting the wire feeder between the WF1 and WF2 from the setup panel
or between the Wire feeder 1 and Wire feeder 2 from the web user interface. The extension
card should indicate the selection by amber LED lights. After successful installation, switch
the power source o and close the robot interface unit.
Follow these steps to install the extension kit:
7. Unscrew four screws, two from the front panel and two from the back panel.
8. Slide the top cover o by pulling from the handle in the front panel.
9. Remove the plug from the extension connector slot.
10. Mount the switching card side by side with the touch sensor card.
11. Fix the secondary wire feeder control connector to the extension connector slot
by using four screws.
12. Unplug the primary wire feeder from the motherboard A101 and from the touch
sensor card A102.
A101
X2
X2
X3
X3
A105
A102
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info