686369
20
Zoom out
Zoom in
Previous page
1/66
Next page
20
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.13.3 Outputs
The outputs have separate three-pole connectors, the rst
4 outputs on the main card and the last 4 outputs on the
extension card. The connectors have identical pinout (see
Figure 3.22, “Output connector pinout”). The outputs are
galvanically isolated from each other and from the other
hardware of the I/O device. The outputs have individual
short-circuit-protected +24 V DC power supplies, each
providing up to 100 mA of continuous current.
1
2
3
Figure 3.22: Output connector pinout
1. Supply out +24V, 100 mA
2. Output signal
3. Supply GND
The outputs are capable of driving loads up to 100 mA
and they are fully compatible with +24 V industrial logic.
The output signal is pulled up by a 10 k resistor. See the
following gures for connection examples. The output
conguration is described in Section 5.4, “Inputs and
outputs”.
1
2
3
Figure 3.23: Driving a relay or a valve
1
2
3
Figure 3.24: Interfacing with a PLC
1
2
3
Figure 3.25: Driving a LED indicator
1
2
3
Figure 3.26: Driving a load by using an external +12 V - +48 V
DC power supply
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info