686369
12
Zoom out
Zoom in
Previous page
1/66
Next page
12
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.8.2 Wire feeder control cable
The wire feeder control cable provides power to the wire
feeder and transmits the control data between the wire
feeder and the robot interface unit. It also contains the
touch sensor voltage line from the robot interface unit to
the wire feeder.
Figure 3.12: Wire feeder control cable connector pinout
A. Power supply +50 V
B. Data in/out
C. (not connected)
D. (not connected)
E. (not connected)
F. Power supply GND
G. Touch sensor voltage (+50…+200 V)
At the wire feeder, make the connection to the
control cable connector.
At the power source, connect the cable to the
control cable connector at the rear of the robot
interface unit.
At the power source, the connector must be connected
to the back of the robot interface unit. Do not use any other
control cable connectors.
3.8.3 Welding cable
The welding cable delivers welding power from the power
source to the welding head.
At the wire feeder, connect the cable to the screw
terminal on the front of the unit.
At the power source, connect the cable to the (+)
connector on the back of the power source unit.
3.8.4 Shielding gas hose
The shielding gas hose delivers the shielding gas to the
welding torch.
At the wire feeder, connect the hose to the shielding
gas snap connector.
Connect the other end of the hose to the shielding
gas supply.
3.8.5 Cooling hoses
Cooling hoses deliver the cooling liquid from the cooling
unit to the welding head.
At the wire feeder, connect the cooling hoses
directly to the hoses coming from the welding
torch.
At the power source, connect the cooling hoses
to the cooling unit located under the power
source.
The wire feeder does not have connectors for cooling
hoses. Use special adapters if required.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info