686369
11
Zoom out
Zoom in
Previous page
1/66
Next page
11
A7 MIG Welder© Kemppi Oy 2018 1804
INTEGRATION GUIDE
3.8 Interconnection cable set
The interconnection cable set contains several cables and
hoses wrapped in a strong fabric sleeve equipped with
a zipper. The cable set is used for delivering the welding
power, shielding gas, cooling liquid, and control signals
from the welding power source to the wire feeder.
The interconnection cable set is available with and without
cooling hoses.
A
D
E
C
B
Figure 3.11: Interconnection cable set (wire feeder end)
A. Arc measurement cable
B. Cooling hoses
C. Shielding gas hose
D. Welding cable
E. Wire feeder control cable
3.8.1 The arc measurement cable
The arc measurement cable is a part of the arc voltage
measurement function, which is used to calibrate the
actual arc voltage and power regardless of the welding
cable diameter or length.
Connect the cable to the arc measurement input
connector at the rear of the power source.
Connect the cable to the arc measurement
output connector at the wire feeder.
For using the arc voltage calibration, connect a
separate earth cable (included in the package)
from the wire feeder to the work piece, near the
weld joint.
Check the route of the earth cable. Incorrect routing
can cause damage to the cable or the robot when the
robot is moving.
When the system is ready to run, calibrate the power
source by welding with 1-MIG, MIG or with Pulse MIG for
at least 5 seconds, with the arc measurement cable and
the earth cable connected. After calibration the earth
cable can be detached, although it is recommended to
use it always. The cable is required when monitoring arc
voltage.
Using the arc measurement cables aects the
functionality of the touch sensor. See the A7 MIG Welder
Operating manual for details.
If you are using a sub-feeder, enter the length of
the sub-feeder to the SubFeederLength parameter in the
setup panel. This parameter is not available in the web
user interface.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG Welder 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG Welder 350 in the language / languages: English as an attachment in your email.

The manual is 5,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info