686364
13
Zoom out
Zoom in
Previous page
1/19
Next page
13
A7 MIG Gun 500-g© Kemppi Oy 2017 1712
OPERATING MANUAL
12. OPERATION
Shortness of breath and poisoning caused by inhaling
phosgene gas
Phosgene gas is formed during the welding of work pieces
that have been degreased with chlorine-containing
solvents.
Do not inhale fumes and vapors.
Ensure a sucient supply of fresh air.
Rinse the work pieces with clear water prior to welding.
Do not place degreasing baths containing chlorine in the
vicinity of the welding area.
Risk of burns
During welding work that sprays sparks, glowing work
pieces or hot slag can produce ames.
Check the work area for seats of re.
Make suitable re-extinguishing materials available in the
work location.
Allow the work pieces to cool down after welding.
Before performing welding work, fasten the ground clamp
properly to the work piece or the welding table.
Dazzling of the eyes
The arc produced by welding may damage the eyes.
Wear suitable protective clothing and eye protection.
The welding torch may only be operated by qualied
personnel.
Ensure that all required parameters, such as the welding
current and wire feed, have been set at the welding power
supply in accordance with your welding task.
12.1 The welding process
This section describes the welding process.
Proceed as follows:
1. Open the shielding gas cylinder.
2. Switch on the power supply.
12.2 Completing the welding process
This section describes how to quit when the welding
process has been done.
Proceed as follows:
1. Wait until the shielding gas ow has subsided.
2. Close the shut o valve for the gas supply.
3. Switch o the power supply.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi A7 MIG gun - 500g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi A7 MIG gun - 500g in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info