738040
12
Zoom out
Zoom in
Previous page
1/20
Next page
12
M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
The Adjustment Knobs allow the Handles to adjust in increments of 1 inch
(25 mm) to attain a comfortable reach distance. To set the Handles using
the Adjustment Knobs, refer to Figure 10 and follow the instructions below:
1. Loosen the Adjustment Knob by turning it counterclockwise 1/4 -
1/2 turn.
2. Pull the Knob outward and hold.
3. Slide the Handle freely to the desired position.
4. Release the Knob. Ensure it locks into the desired position hole.
5. Turn the Knob clockwise until it is hand-tight to secure the Handle.
NOTE: For proper reach setting, ensure that your elbows maintain a
slight bend when the Handles are pushed out to the furthest position.
Figure 10. How to Adjust the Handles
1
2
4
5
3
Adjustment Knob
Handle
Recoiler Safety Straps help increase wheelchair stability and must be used at all times during exercise. Wheelchair brakes must
be locked during exercise (powered mobility devices turned off). To set the Recoiler Safety Straps, follow the instructions below.
NOTE: When done exercising, lift the Recoiler Lock Lever up to unlock. Detach the Safety Strap Hooks and allow them to feed
back into the Recoilers.
RECOILER SAFETY STRAPS
2
Attach the Safety Strap Hooks above
Seat Level (i.e. arm rest).
CAUTION: TIP HAZARD. Safety
Strap Hooks attached below Seat Level
increases the chance of tipping backwards
and could result in bodily injury. Always
attach Safety Strap Hooks ABOVE SEAT
LEVEL.
(A) Lift the Recoiler Lock Lever up to
unlock and (B) pull the Safety Strap Hook
out.
1
A
B
(A) Check for tightly drawn Recoiler
Safety Straps with no looseness, then
(B) push the Recoiler Lock Lever down
to lock in place. If your wheelchair feels
like tipping back, stop in a controlled
manner and repeat the entire procedure
to adjust the Safety Straps until stability
is achieved.
3
B
A
Lock Lever
Lock Lever
Recoiler Safety
Strap/Hook
Seat Level
Straps are
Tight
ADJUSTMENT KNOBS
Figure 9. How to Fasten the Footstraps
FOOTSTRAPS
Individuals with limited lower body control should always secure their
feet with Foot Straps when operating the M7i. To set and fasten the
Footstraps, refer to Figure 9 and follow the instructions below:
1. Place your foot under the Foot Strap and onto the Footpad with
your heel resting against the rear wall of the Footpad.
2. Pull the Foot Strap end up and away from your foot to tighten the
Foot Strap to your foot.
3. Press the hook and loop surfaces rmly together to fasten. Ensure
the Foot Strap is snug to t without causing discomfort.
CAUTION: Always wait for the M7i to come to a complete stop before
attempting to adjust the Foot Straps.
1
2
3
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keiser M7i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keiser M7i in the language / languages: English as an attachment in your email.

The manual is 15,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info