738033
8
Zoom out
Zoom in
Previous page
1/28
Next page
Mounting Computer
Step 1: Obtain the #2 Phillips screwdriver and remove the computer mounting screw from the handlebar tube.
Step 2: Coil the computer cable into the computer mount cavity.
Step 3: Slide the computer up into the two locking ears. Insert and secure the screw you removed in Step 1 using the #2
Phillips screwdriver.
Calibrating the Computer
To calibrate the computer:
The shifter lever must be in the down position. Holding a pedal, rotate the crank arm in any direction to switch the
computer on. Once the computer is on, stop rotating the crank arm. Move the shifter lever from full bottom to full top a
minimum of ve times. When you see the computer display a set of number ves (55:55) in the time display, the computer
is calibrated.
1. Cycle display must be blank. If the display is not blank wait about 50 seconds until it is blank.
2. Activate the display by rotating the crank pedal. As soon as it is active stop the crank movement.
3. Move the shifter from full retract (lowest resistance) to full advanced (highest resistance) at least ve times. These ve
retractions must be done within ve seconds.
4. Computer will indicate it is calibrated by showing “55:55”. If you do not see the “55:55” start over from step # 1.
5. Retract shifter (lowest resistance) and computer should show gear “1”. Advance shifter (increase resistance) and
computer should show gears changing “1” through “24”.
6. Continue beyond gear “24” and “88” will ash. This is the emergency brake area, where the end of the shifter is about
1” to 1 ¼” off the top of the handlebar. If you do not see the ashing “88” start over from step # 1.
1
2
6
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Keiser M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Keiser M3 in the language / languages: English as an attachment in your email.

The manual is 44,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info