631709

Kathrein CAP 730 - MobiSet 3 Twin Manual

20
Zoom out
Zoom in
Previous page
1/64
Next page
20 from 64
Installation and connection
5.6 Installation of the UFS 946/CI+
5.6.1 Selection of a suitable installation location
The four screw sockets provided (see diagram on the next page) allow you to install the receiver not only
restingonashelfbutalsotoxitthereorinotherpositions.
In addition, the following points should be taken into account:
● The wall thickness at the installation location must be at least 15 mm, as otherwise the screws will
break through on the other side or damage the surface
● Ensure that the cupboard or storage compartment in which the unit is housed is adequately ventilated,
to prevent a build up of heat. Carpet-covered walls are unsuitable for installation
● Take care when tightening the screws not to damage any cables etc., behind or in the wall
● The receiver is designed for installation in exclusively dry, interior locations. The installation location
must be protected against moisture
● The cable lengths must be taken into account when choosing the installation location
● The connecting cables must be provided with strain reliefs
Ventilation
The heat generated within the receiver
can be dissipated from the following sides
of the casing: Bottom, left, right and top.
When selecting the installation loca-
tion, make sure that these sides are not
obstructed or covered. If the unit is oper-
atedcontinuouslywithinsufcientventila-
tion, this can negatively affect the length of
itsworkinglife!
Maintain a clearance of at least 20 cm
above or below the unit, 2 cm to either
side and 5 cm behind it, to allow unob-
structed dissipation of the heat generated.
Minimum
clearance
20 cm
2
cm
2
cm
5 cm
5
cm
Important
Danger of damage. The unit monitors its own temperature in operation. Premature failure of the
unit due to continuous operation at temperatures higher than the recommended operating tem-
peratureasaresultofinsufcientventilationdoesnotconstitutegroundsforaclaimunderwar-
ranty / guarantee.
Note
When choosing the installation location, bear in mind that the rear of the unit should always be acces-
sible. The receiver is equipped with a power saving circuit and a separate infrared transmitter, which
meansthattheunitdoesnotneedtobeplacedwhereitisvisible.Youcanthereforetthereceiverout
of sight in any location, e.g. on cupboard walls, side walls or the base of storage compartments.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kathrein CAP 730 - MobiSet 3 Twin at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kathrein CAP 730 - MobiSet 3 Twin in the language / languages: English as an attachment in your email.

The manual is 8,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kathrein CAP 730 - MobiSet 3 Twin

Kathrein CAP 730 - MobiSet 3 Twin User Manual - German - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info