724919
11
Zoom out
Zoom in
Previous page
1/144
Next page
English 11
3. Where necessary, remove residue from
the hose and on Quick-Connect.
4. Pull the mains plug out of the socket.
Transportation
Carry the device.
Lift up the device by the carrying han-
dle, and carry it.
Fasten a rope to the carrying handle,
and use the rope to lift up the device -
and carry it.
Transport the device in a vehicle.
Secure the device against slipping
and tipping over.
Storage
ATTENTION
Danger of frost
Incompletely emptied devices can be de-
stroyed by frost.
Completely empty the device and accesso-
ries.
Protect the device from frost.
1. Completely empty the pump.
2. Allow the pump and the hose to dry out.
3. Store the pump in a frost-protected
place.
Care and service
The device is maintenance-free.
Troubleshooting guide
Malfunctions often have simple causes that
you can remedy yourself using the follow-
ing overview. When in doubt, or in the case
of malfunctions not mentioned here, please
contact your authorised Customer Service.
The pump is running, but not delivering
Air is in the pump.
1. Pull the mains plug out of the socket and
plug it in again several times, until the
fluid is drawn in.
The suction area is clogged.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
The fluid level is too low in manual opera-
tion.
1. Immerse the pump deeper into the feed
fluid if possible, see chapter .
The pump does not start up, or stops
suddenly during operation
The power supply is disconnected.
1. Check the fuses and the electrical con-
nections.
The thermal protection switch has switched
off the pump because of overheating.
1. Pull the mains plug out of the socket.
2. Allow the pump to cool down.
3. Remove any dirt particles in the suction
area.
4. Clean the suction area.
5. Prevent the pump from running dry.
Dirt particles block the suction area.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
The pumping capacity decreases
The suction area is clogged.
1. Pull the mains plug out of the socket.
2. Clean the suction area.
The pumping capacity is too low
The maximum delivery height is exceeded.
The hose diameter and the hose length
have been selected incorrectly.
Observe the maximum delivery height,
see chapter Technical data.
When necessary, select a greater hose
diameter or a shorter hose length, see
chapter Optimising the flow rate.
Quick-Connect cannot be opened or
closed
The push-fit system is dirty.
1. Remove the clip.
2. Clean the clip.
3. Install the clip.
The filter basket cannot be moved.
The filter basket is dirty.
1. Loosen the latch screws using a screw-
driver.
2. Remove the filter basket.
3. Clean the filter basket.
4. Install the filter basket.
Technical data
Electrical connection
Mains voltage V 230-240
Power frequency Hz 50
Nominal power W 500
Performance data of device
Flow rate (max.) l/h 9500
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher SP 5 Dual at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher SP 5 Dual in the language / languages: All languages as an attachment in your email.

The manual is 3,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info