2120
8.2. 12-24 hour display
Press T4 once the desired time zone has been
set. You can now choose between the 12-hour
time display (am/pm) and the 24-hour time
display.
The upper part of the display shows the
display mode that is currently selected and
this can be changed using T1 (set+) and T2
(set–).
Press T4 until time display is selected (time
display mode 1). The display shows the time.
T4 is used to adjust the time zone. When the
time zone is adjusted the main time display
changes to show the time in this time zone.
Press T4 for more than 3 seconds.
The upper part of the display shows ”1.
TIME”, the hour figure flashes and can be
adjusted by the hour using T1 (set+) and T2
(set–). Where necessary the date is automati-
cally adjusted at the same time.
To reset the main time to your home time (see chapter 8.3 ”home
time”), press T2 for more than 3 seconds when in one of the 5 time
display modes. The main time display then shows the selected home
time again. If the home time has not been set manually then the time
zone of the transmission station that was last used for synchronisation
is shown.