602019

Janome Memory Craft 11000 Special Edition Manual

36
Zoom out
Zoom in
Previous page
1/112
Next page
37
Sensor (Square) buttonhole
Select pattern B1.
To sew
1 Attach the automatic buttonhole foot R snapping the
pin into the groove of the foot holder. Raise the
presser foot.
2 Pull the button holder to the rear, and place the
button in it. Push it tightly against the button.
NOTES:
The buttonhole size is automatically set by placing a
button into the button holder in the rear of the automatic
buttonhole foot R.
The button holder of the foot takes a button size of up to
2.5 cm (1") in diameter.
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric. If it is difficult to fit the
button through the test buttonhole, you can lengthen the
buttonhole by pulling the button holder back a little. The
length of the buttonhole will be increased.
3 Pull the buttonhole lever down as far as it will go.
4 Press the start/stop button to sew the buttonhole.
NOTE:
A warning message will appear and the machine will
stop automatically if you start to sew a buttonhole
without pulling down the buttonhole lever.
Press the exit key and pull down the buttonhole lever to
restart.
5 When buttonhole sewing is finished, push the
buttonhole lever up as far as it will go.
6 Remove the fabric and place a pin just below the
bartack at each end to prevent accidentally cutting
threads. Cut the opening with the seam ripper. Use
an eyelet puncher to open a keyhole buttonhole.
4
Buttonholes(B)
6
2
3
5
7
8
9
10
11
12
13
14
15 16
R
17 18 19 20 21
1
Sensor BH
Pull down BH Lever.
Auto
B
NOTE:
Make sure there is no gap between the slider and front
stopper, otherwise the left and right lengths will be
different.
X
Pull down BH Lever.
1
2
3
4
5
6
No gap
Step-1
Step-2 Step-3
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome Memory Craft 11000 Special Edition at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome Memory Craft 11000 Special Edition in the language / languages: English as an attachment in your email.

The manual is 18,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info