472825
26
Zoom out
Zoom in
Previous page
1/60
Next page
22
Basting
q Stitch selector: 20
w Needle thread tension: 1 to 3
e Presser foot: Darning foot: P
r Feed dog: Dropped
Attaching the darning foot
q Foot holder
w Thumb screw
e Pin
r Needle clamp
z Raise the needle.
x Remove the foot holder q by loosening the thumb
screw w.
c Attach the darning foot on the presser bar putting
the pin e on the needle clamp r. Tighten the thumb
screw w firmly with a large screwdriver.
•To sew
z Lower the feed dog.
x Set the thread tension dial between 1 and 3.
c Put some fabric under the foot and press up/down
needle position button twice to bring the needle thread
down through the hole in the foot. Pull the fabric and
thread to the rear. Lower the presser foot.
v Press down the foot control. The machine stops after
each stitch.
b Move the fabric to where you want the next stitch.
n Repeat steps v to b to sew. After finishing sewing,
pull the threads and fabric to the rear side.
* After sewing, reset tension to “4”. Return feed dog lever
to raised position. Feed dog will rise when sewing
resumes.
q wer
z x
c
z x c v b n
q
w
w
e
r
1
2
1
2
To drop or raise the feed dog
The drop feed dog lever is located underneath the free arm
bed on the back side of the machine.
q To drop the feed dog, push the lever in the direction
of the arrow, as illustrated.
w To raise the feed dog, push the lever in the direction
of the arrow, as illustrated, and turn the handwheel
toward you. Feed dog must be up for normal sewing.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Janome DC5100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Janome DC5100 in the language / languages: English as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info