631258
8
Zoom out
Zoom in
Previous page
1/13
Next page
The JA-82Y GSM communicator installers manual 8/8 MDL51108
The communicator registration code xxxxx-xxxxx-xxxx. The code is stated
on the label on the communicator board, in the OLink application or you
can have it sent to you by SMS (see 6.23)
The telephone number of the communicator SIM card
The remote access password (see 6.24)
When GPRS is not available a connection with OLink can be realized by
SMS with limited capabilities. After GPRS has been restored, the system
automatically starts to use the GPRS connection.
8.5. Time synchronizing process
The right and accurate time is taken from the GSM network via received SMS
messages or from the Jablotron YTUN server when GPRS is active. When the
communicator has not got time synchronization information, it sends an SMS to
itself via the GSM network (1x per 10 days). There is one requirement, the
communicator must have its own SIM card number saved in position 0 by the
sequence 81 0 xxx..x *0 (xxx..x = own telephone number). If you change the SIM
card, position 0 will be automatically erased.
Time synchronization (see section 6.17) of the control panel is performed
whenever entering into service mode or maintenance mode, and if there is a
difference greater than 5 minutes between the correct time and control panel time,
synchronization is performed automatically in an unset system without needing to
manually change modes.
Notes:
Synchronization is indicated by a keypad beep
PG outputs are deactivated during time synchronization, then the outputs
are reactivated afterwards.
A time synchronization event is sent to the ARC by automatically entering
service/maintenance mode (even when unset) and CID report code 1625
(625 means a time and date reset based on the norm DC-05) is transmitted
before exiting service/maintenance mode.
9. Technical specifications
Power 12V DC (from the control panel)
Stand-by consumption (mean value) about 35 mA
(depends on the GSM signal strength)
GSM band QUAD-BAND, 850/900/1800/1900MHz
Complies in configuration CIE OASIS system with EN 50131-1, EN 50136-2-1
as follows: ATS 4, ATS 5 if CID protocol is used
and the repeating period is set to zero (Sequence 06p0)
Operating environment – indoor general (-10°C to 40°C) Class II
Security Grade 2
Safety EN 60950-1
EMC ETSI EN 301489-1, ETSI EN 301489-7
EN 55022, EN 50130-4
Radio transmissions ETSI EN 301419-1 and EN 301511
CLIP protocol (caller ID + SMS) ETSI EN 300 089
Can be operated according to GSM Regulations
JABLOTRON ALARMS a.s. hereby declares that the JA-82Y is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. The original of the conformity
assessment can be found at www.jablotron.com - Technical
Support section
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use. More detailed information
can be found at www.jablotron.com - Technical Support
section
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron JA-82Y GSM communicator at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron JA-82Y GSM communicator in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Jablotron JA-82Y GSM communicator

Jablotron JA-82Y GSM communicator User Manual - English - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info