803711
126
Zoom out
Zoom in
Previous page
1/140
Next page
126
?Open the lever; turn the tension adjusting nut clockwise a quarter turn; then try again.
(5) If the lever cannot be pushed all the way to a position parallel to the fork blade, return the lever to the
OPEN position. Then turn the tension adjusting nut counterclockwise one-quarter turn and try tightening the
lever again.
(6) Close the brake shoes; then spin the wheel to make sure that it is centered in the frame and clears the
brake shoes.
WARNING: Secondary retention devices are not a substitute for correct quick release adjustment. Failure to
properly adjust the quick release mechanism can cause the wheel to wobble or disengage, which could cause
you to lose control and fall, resulting in serious injury or death.
c. Removing a Quick Release Rear Wheel
(1) Shift the rear derailleur to high gear (the smallest, outermost rear sprocket).
(2) Open up the brake shoes.
(3) Pull the derailleur body back with your right hand.
(4) Rotate the quick-release lever to the OPEN position.
(5) Lift the rear wheel off the ground a few inches and, with the derailleur still pulled back, push the wheel
forward and down until it comes out of the rear dropouts.
d. Installing a Quick Release Rear Wheel
(1) Shift the rear derailleur to its outermost position
(2) Pull the derailleur body back with your right hand.
(3) Rotate the quick-release lever to the OPEN position. The lever should be on the side of the wheel
opposite the derailleur and freewheel sprockets.
(4) Put the chain on top of the smallest free wheel sprocket. Then, insert the wheel into the frame dropouts
and pull it all the way in to the dropouts.
(5) Tighten the adjusting nut until it is finger tight against the frame dropout; then rotate the lever toward the
front of the bike until it is parallel to the frame’s chainstay or seatstay and is curved toward the wheel.
CAUTION: If you can fully close the quick release without wrapping your fingers around the fork blade for
leverage, and the lever does not leave a clear imprint in the palm of your hand, the tension is insufficient.
Open the lever; turn the tension adjusting nut clockwise a quarter turn; then try again.
(6) If the lever cannot be pushed all the way to a position parallel to the chainstay or seatstay tube, return the
lever to the OPEN position. Then turn the adjusting nut counterclockwise one-quarter turn and try tightening
again.
(7) Push the rear derailleur back into position.
(8) Close the brake shoes; then spin the wheel to make sure that it is centered in the frame and clears the
brake shoes.
!
126


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Izip Enlightened Series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Izip Enlightened Series in the language / languages: English as an attachment in your email.

The manual is 6.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info