790021

Inventum VWM9001B Manual

49
Zoom out
Zoom in
Previous page
1/116
Next page
English •49
CLEANING THE INLET FILTER AT THE BACK OF THE APPLIANCE
1. Close the water tap.
2. Unscrew the water supply hose from the back of the appliance.
3. Pull out the filter with a long nose plier and clean the filter using a brush under
runningwater.
4. Reinstall the filter to the water inlet and reconnect the water supply hose.
5. Open the water tap.
CLEANING THE DISPENSER TRAY
1. Press the small tab and pull the dispenser tray out of the recess.
2. Clean the dispenser tray under running water using a brush, and dry it.
Also, remove any detergent residue from the bottom of the housing.
Make sure not to forget to clean the drain hole of the softener compartment
and the openings at the bottom ofthe dispenser tray.
3. Clean the inside of the recess with a brush.
4. If required, remove and clean the plug cap.
5. Clean the plug cap under running water and replace it.
6. Push the dispenser tray back in the recess.
i
• Do not use abrasive or caustic agents to clean plastic parts.
• Cleaning the dispenser tray every 3 months ensures normal operation
of the appliance.
CLEANING THE DRAIN PUMP FILTER
The pump filter can filter the yarns and small foreign matters from the washing. Especially after washing fleecy, woolly or
very oldlaundry.
Clean the pump filter and the in-wall water trap whenever the symbol appears on the display unit.
WARNING!
• Unplug the appliance to avoid electrical shock before cleaning.
• Be careful of hot water!
• Allow detergent solution to cool down.
• During cleaning, some water may be spilled. It is recommended to place an absorbent cloth on the floor.
1. Open the pump filter cap using a suitable tool (flat screwdriver or
asimilar tool).
2. Pull out the water outlet funnel before cleaning the pump filter. Rotate
the pump filter slowly in the counter clockwise direction. Pull out and
remove the pump filter to allow the water to drain slowly.
3. Clean the pump filter thoroughly under running water.
4. Remove all and any objects and impurities from the filter housing and
the pump propeller. Replace the pump filter as shown in the figure
and fasten it by rotating in the clockwise direction. For a good seal,
thefilter gasket surface should be clean.
WARNING!
• Never remove the pump filter cap during a washing cycle. Always wait
until theappliance has finished the cycle and is empty.
• When the appliance is in use and depending on the selected
programme, therecan be hot water in the pump.
• When replacing the pump filter cap, ensure it is securely snapped
inplace.
… 49 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum VWM9001B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum VWM9001B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info