550038
11
Zoom out
Zoom in
Previous page
1/18
Next page
192
A
S AVE THESE INSTRUCTIONS
(192IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
English
Page 11
SET UP (continued)
De ation
For Spa Tub Wall:
1. Unscrew the cap to reveal the stem, push the stem in
and turn 90 degree right to secure it in the down
position (see drawing 8).
2. Once the de ation is completed, push the stem in and
turn 90 degree left to return it to the in ation position.
3. Replace the cap back.
For Cover Air Bladder:
1. Pull valve cap out and squeeze the valve at its base
until de ated.
2. Close and recess the valve back.
Spa Control Unit Installation
1. Press the button located on top of the control base and remove the back cover (see drawing 9).
2. Connect the spa control unit to the spa tub (see drawing 10). Hand-tighten the connectors securely.
Do not use tools to tighten.
3. Reinstall the back cover (2) to the spa control base (see drawing 11). Back cover must be installed
before using the SPA.
CAUTION: Do not sit, lean, cover or place any objects over the spa control unit.
4. Attach the lter cartridge housing assembly to the inside of the spa
tub outlet grid (lower position, marked “C”) (see drawing 12).
5. Before lling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
6. Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over ll the spa.
WARNING: Never pour water with a temperature higher than
104°F (40°C) into the spa directly. It is recommended to ll the
spa tub with lukewarm water for quick heating and energy saving.
7. Place the spa cover and spa air bladder (pre-installed in spa cover)
over the spa tub, and make sure the spa cover buckles are locked
using the key provided after pulling the buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature
wear and tear or deterioration. Never use a damaged spa cover.
8. Turn on the heater on the spa control unit see “Spa Control Unit Panel” operating instructions section. The
heating system is capable of increasing the water temperature by approximately 3-4.5ºF (1.5-2.5ºC) per
hour.
8
11
2
10
A
B
C
B
C
A
9
Press
12
C
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex Pure Spa at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex Pure Spa in the language / languages: English as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Intex Pure Spa

Intex Pure Spa User Manual - German - 24 pages

Intex Pure Spa User Manual - Dutch - 19 pages

Intex Pure Spa User Manual - French - 21 pages

Intex Pure Spa Additional guide - All languages - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info