738441
19
Zoom out
Zoom in
Previous page
1/38
Next page
Step 18: Assemble one end of Upper Cable by sliding the plastic ball onto the end of the cable. Next slide the
cable end into the side of the U bracket and to the bottom of the U. Attach Spring Clip to U bracket using Button
Head Bolt and T nut as shown. Slide the rubber washer against the ball. If both ends are assembled, take one end
apart.
Start at one of the lat swivel pulleys (Note if it is the Left or Right side when sitting in the machine. Feed the
unassembled end of the cable around pulleys as shown for that side of the machine (may help to slide the rubber
washer back 10” (25cm) to feed through press arm mounts). Let a loop hang down in back for use with the
weight stack and then continue to route the other side of the machine from back to front. Continue this process on
the next page.
Page 16
Make sure to route
the cable between
the pulley and the
barrels pointed out
by the arrows
Step 18
1 Plastic Ball
1 Cable “U” Bracket
1 M6 x 12 Button Head Bolt
1 Spring Clip
1 M6 T Nut
Upper Cable: This
section of cable loops
down and back up to
the other side to
continue. This loop
will attach to the
weight stack pulley
later.
Left side when sitting on machine.
Pulley 17
Note: Make sure
to route Cable
above the press
arm stop.
Adjustable
Floating Pulley
Assembly
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire M3 in the language / languages: English as an attachment in your email.

The manual is 9,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info