738441
21
Zoom out
Zoom in
Previous page
1/38
Next page
Step 18b: Assemble one end of the Middle Cable (as shown in Step 18, page 18) by sliding the plastic ball onto
the end of the cable. Next slide the cable end into the side of the U bracket and to the bottom of the U. Attach the
Spring Clip to the U bracket using a Button Head Bolt and T nut as shown. Slide the rubber washer against the
ball. If both ends are assembled, take one end apart.
Start at the Middle Pulley. Feed the unassembled end of the cable over and behind Mid Pulley, down, in front of
and under Ab Pulley, through upright to and over Pulley 19, down in front of Pulley 12. Let cable end sit on base
and use a screw driver through the hole in Upright to push the cable end back and under Pulley 12, then under
Pulley 18 and up and around the Lower Floating Pulley as shown. Next, go down and under Swivel pulley to
outside. Assemble the cable end as at the start of this step. Slide the rubber washers against each of the plastic
balls on the cable ends.
Tighten both ends of the cable Now. Page 18
Mid Pulley
Swivel Pulley
Pulley 18
Pulley 12
Ab Pulley
Pulley 19
Hole in Upright
Lower Floating Pulley
Middle Cable
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire M3 in the language / languages: English as an attachment in your email.

The manual is 9,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info