615947
14
Zoom out
Zoom in
Previous page
1/25
Next page
FiberTEK III Document 164802 Iss 3
User Manual Page 14
Fig. 3 One Jumper Field Calibration
If it is not possible or practical to plug the cable under test directly into the Rx
Port (for example if it is a Permanent Link) the 3-Jumper test method must be
used instead. For Field calibration in this method, 3 jumpers are used in each
direction - a Launch Cord, a Field Calibration Cord and a Tail Cord.
Fig. 4 Three Jumper Field Calibration
For testing cables where both ends are available in one location, a Loopback
method is provided. This method uses only the Display Handset. A 1-Jumper or
a 3-Jumper Field calibration can be performed, depending on whether it is
possible to plug the cable to be tested directly into the Tx and Rx Ports of the
FiberTEK™ III .
Fig. 5 Loopback Field Calibration (1-Jumper)
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ideal Networks FiberTEK III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ideal Networks FiberTEK III in the language / languages: English as an attachment in your email.

The manual is 0,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info