744526
11
Zoom out
Zoom in
Previous page
1/20
Next page
Page 11 of 20 pages
Model Weight Height Width Depth
HWAM 3740c/3740m: 104/101 kg 102.5 cm 49.9 cm 37.5 cm
HWAM 3760c/3760m: 117/113 kg
125.4 cm
49.9 cm 37.5 cm
Heat storing slabs, HWAM 3760 32 kg
The stove is mainly made of sheet iron, with some items made of cast iron.
Floor plate
European, national and local regulations must be observed in terms of the size and thickness of a non-
combustible floor covering the floor in front of the combustion chamber opening. Ask your HWAM
retailer for assistance. The combustion chamber opening is 34.0 cm wide.
Distance to inflammable materials
Your HWAM woodburning stove should always be installed on a non-combustible hearth. If it is installed
on a wooden floor or similar, the floor must be covered with a non-combustible material.
HWAM 3740, HWAM 3760 (Drawing A)
1. Recommended for brick wall
10 cm
1.
For inflammable back wall
10 cm
2.
For inflammable side wall
35 cm
1.
To inflammable wall,corner installation
9 cm
3.
Distance to furnishings in front
90 cm
Remember to pay attention to applicable regulations concerning the required distance
between the wall and smoke pipe.
The distance to a brick wall is set to faciliate the servicing of the HWAM
®
Autopilot™ system.
Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes
be treated as a flammable wall, in which case we ask you to contact your local chimney sweep or glass
producer to hear at what distance the stove should be kept from glass.
Requirements for chimney and smoke pipe
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems.
The stove requires a draft of at least 12 Pa.
The chimney must have a minimum opening equivalent to Ø 150 mm. The chimney opening should always
be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Changing the smoke outlet from top outlet to rear outlet - HWAM 3740 (drawing I)
If a wood-burning stove from the factory is supplied with a top outlet but you want to change it to a
rear outlet, this can be done by following the instructions below. If this change is made, a closed top plate
without a hole for the top outlet can be purchased.
1. Removing the external heat shield (1). Lift the heat shield (1) up and remove it from the stove. The
heat shield has a cut-out for the flue duct. Break off the pre-cut plate (2); the resulting hole fits the
flue duct.
2. Removing the rear plate (3). Lift the rear plate and pull it away from the stove so that it disengages
from the guide pins (4) on the bottom plate of the stove. There is a cut-out in the rear plate for the
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3740 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3740 in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3740

Hwam 3740 User Manual - German - 20 pages

Hwam 3740 User Manual - Dutch - 20 pages

Hwam 3740 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info