744526
18
Zoom out
Zoom in
Previous page
1/20
Next page
Page 18 of 20 pages
Insulation
The efficient, but porous insulation of the combustion chamber may, in time, become worn and damaged.
Cracks in the insulation have no effect on the efficiency of the stove. The insulation should be replaced,
however, when it is reduced to less than half the original thickness due to wear and tear.
HWAM
®
Autopilot™ (Drawing G)
Lift off the rear panel. On a cold stove, the starting point of the feeler is controlled. The starting point on
a cold stove is about 30
0
above horizontal.
It should feel easy going and bouncy when you push it, no matter if the stove is cold or hot. By rising or
falling temperatures it must not move at a bound. The damper plates must be dry and clean and slide
together unhindered. Control bars and slide gates may have to be smeared with WD40 (never oil).
Door/glass
A sooty glass door can easily be cleaned with a piece of moist kitchen roll dipped in ash. Go about it
in vertical movements (up and down). Follow up with a dry piece of kitchen roll. Check frequently to
ensure that seals in the door and ash pan are intact and not brittle. Failing this, they should be replaced.
Use original seals only.
Surface
Usually, it is not necessary to any treatment to the painted surfaces of the wood-burning stove. Any dam
-
age to the paint may, however, be remedied with spray paint, which can be bought from your stove dealer.
Guarantee
The guarantee does not cover damage due to insufficient maintenance!
opEratIonal problEms
Blackened glass
The wood is too damp. Only use wood stored for at least 12 months under cover and with a
moisture level not exceeding 12-18% RH.
Faulty seal in door. Fit new seal.
Smoke in the room when opening door
The grate in the chimney may be closed. Open the grate.
Insufficient chimney draft. See section on chimney or contact chimney sweep.
Soot door leaking or dislodged. Replace or refit.
Never open the door when there are still flames on the wood.
Uncontrollable combustion
Faulty seal in door or ash pan. Fit new seal.
If there is an excessive chimney draft, it may be necessary to set the regulator to its minimum position.
Also do this when the stove is not in use.
If the steel plates in the combustion chamber develop scales or become deformed, this is due to
excessive heat. Stop using the stove and contact the dealer.
At interruptions that you cannot yourself rectify, you should contact the dealer.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3740 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3740 in the language / languages: English as an attachment in your email.

The manual is 2,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3740

Hwam 3740 User Manual - German - 20 pages

Hwam 3740 User Manual - Dutch - 20 pages

Hwam 3740 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info