613740
11
Zoom out
Zoom in
Previous page
1/44
Next page
11
HWAM 3120, HWAM 3130, HWAM 3220 (Drawing A)
1. Recommended for brick wall
10 cm
1.
For inflammable back wall
10 cm
2.
For inflammable side wall
20 cm
1.
To inflammable wall,corner installation
13 cm
3.
Distance to furnishings in front
80 cm
Remember to pay attention to the applicable regulations concerning the required distance
between the wall and smoke pipe.
Requirements for chimney and smoke pipe
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems.
The stove requires a draft of at least 12 Pa.
The chimney must have a minimum opening equivalent to Ø 150 mm. The chimney opening should
always be at least the size of the outlet socket of the stove. The chimney must have an easily acces
-
sible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel chimney
on top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate,
in connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note
that bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
Vertical cross-section of smoke flue (Drawing B and C)
B: Top smoke outlet
C: Rear smoke outlet
Steel chimney (9).
Flue gas elbow (10). Fits into smoke flue socket.
Brick-built jamb of flue (11).
Built-in pipe sleeve (12). Fits smoke flue.
Wall rosette (13). Covers disruption to wall around pipe sleeve.
Joint (14). Sealed with packing material.
Smoke outlets (15) of the HWAM stove.
Smoke flue regulating damper (16).
Soot door (17).
Changing the smoke outlet from top outlet to rear outlet, HWAM 3120 (drawing E)
1. Lift the cast-iron top (1) off the stove
2. Remove the two sides of the stove by loosening the screw (2) and removing it. The two screws
(3) should only be loosened (not removed). Lift the sides off.
3. Open the metallic tabs (4) and take the wires out.
4. Pull the lambda sensor coupling (5) free of the wire fastener (6).
5. Remove the heat shield (7) and wire fastener (6) by removing the two screws (8).
6. Remove the cover plate (9).
7. Remove the flue ring (10) and fasten it to the rear of the stove.
8. Use a soft faced hammer, for instance, to break off the top of the heat shield (11) and the wire
fastener (12).
9. Fasten the heat shield (7) and wire fastener (6) to the stove again.
10. Reposition the lambda sensor coupling (5) in the wire fastener (6).
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 3220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 3220 in the language / languages: English, Italian as an attachment in your email.

The manual is 3,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 3220

Hwam 3220 User Manual - German, Dutch, French - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info