734468

Husqvarna ST 427T Manual

12
Zoom out
Zoom in
Previous page
1/200
Next page
America (87 AKI in North America) or higher, and with a
maximum of 10% ethanol (E10).
CAUTION: Do not use gasoline with an
octane number less than 90 RON out of
North America (87 AKI in North America).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank, before a start.
To use the fuel switch (for ST
424/427/430 only)
• Turn the fuel switch to open or close the fuel valve.
Operate the product with the fuel switch in the OPEN
position.
OFF
ON
FUELCONTROL
INSTRUCTIONS
To start the engine, manual start
1. Put the ON/OFF key into the ignition slot (B). Do not
turn the key.
B
A
C
D
2. For ST 424/427/430 only: Turn the fuel ON/OFF
switch (C) to the ON position.
3. Put the throttle control (A) to the FAST position.
4. Turn the ON/OFF key to the ON position.
5. For ST 424/427/430 only: If the temperature is lower
than -17 °C (0 °F), push the primer 3 times. See
Product overview on page 2
for primer position.
CAUTION: Do not push the primer too
many times. It can prevent the engine
from starting. If the engine is flooded,
wait some minutes before you try to
start. Do not push the primer.
6. Pull the starter rope handle (D).
CAUTION: Do not release the starter
rope handle quickly. Move it slowly to the
start position.
Note: If the starter rope is frozen, slowly pull out as
much rope out of the starter as you can. Release the
starter rope handle. If the engine does not start, do
the procedure again or use the electric starter.
7. Run the engine 2-3 minutes at very low speed before
you start to throw snow.
8. If the engine does not run smoothly, turn it off.
To start the engine, electric start
1. Put the ON/OFF key into the ignition slot (B). Do not
turn the key.
2. For ST 424/427/430 only: Turn the fuel ON/OFF
switch (C) to the ON position.
3. Put the throttle control (A) to the FAST position.
4. Put the ON/OFF key to the ON position.
B
A
C
D
5. For ST 424/427/430 only: If the temperature is lower
than -17 °C (0 °F), push the primer 3 times. See
Product overview on page 2
for primer position.
CAUTION: Do not push the primer too
many times. It can prevent the engine
from starting. If the engine is flooded,
wait some minutes before you try to to
start. Do not push the primer.
12 891 - 005 - 08.01.2020
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna ST 427T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna ST 427T in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 9,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info