733796
55
Zoom out
Zoom in
Previous page
1/72
Next page
To adjust the parallelism of the cutting deck
1. Loosen the lock nut.
2. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
3. Tighten the lock nut.
4. Do a check of the parallelism. Refer to
To do a
check of the parallelism of the cutting deck on page
54
.
To replace the belt on the cutting deck
WARNING: Only do work on the belt with
the power off and the drive shaft removed.
WARNING: Use eye protection when you do
work on the cutting deck. The belt tension
spring can break and cause injury.
1. Remove the belt covers.
2. Loosen the nut to the belt tension spring.
3. Remove the belt.
4. Install the belt around the pulleys as shown in the
illustration.
5. Tighten the nut until the belt has the correct tension.
50 N
15 mm / 0.6 in.
To charge the 12 V battery
Charge the battery if it is too weak to start the engine,
and during storage of the product.
1. Open the engine cover. Refer to
To open and
remove the engine cover on page 45
.
2. Turn the main switch to OFF.
3. Loosen the 2 screws to the air filter holder. Put the
air filter holder and the air filter to the side.
4. Remove the negative cable from the battery.
5. Remove the positive cable from the battery.
6. Use a standard battery charger to charge the
battery.
7. Install the cables and air filter holder in opposite
sequence.
1262 - 004 - 04.06.2020 55
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 535HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 535HX in the language / languages: English as an attachment in your email.

The manual is 13,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info