733796
53
Zoom out
Zoom in
Previous page
1/72
Next page
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
a) Combi 155 must be measured in 2 areas. Make
sure that the rear edge is 6–9 mm (1/4 - 3/8 in.)
higher than the front edge.
b) Combi 155 X must be measured in 4 areas.
Make sure that the rear edge is 6–9 mm (1/4 -
3/8 in.) higher than the front edge.
To adjust the parallelism of the cutting deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
2. Tighten the nuts on the track rod.
3. Do a check of the parallelism. Refer to
To do a
check of the parallelism of the cutting deck on page
52
.
4. Attach the front cover.
To replace the belt on the cutting deck
1. Remove the 3 screws that holds the belt cover.
2. Remove the belt cover.
3. Attach the service stay to the tension spring.
4. Push the service stay and remove the belt.
5. Attach the belt around the pulleys as shown in the
illustration.
Cutting deck - R180
To examine the blades
WARNING: Damaged or incorrectly
balanced blades can cause damage
to the product. Replace damaged
blades. Let an approved service
agent help you sharpen and balance
blunt blades.
1. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
2. Tighten the blade bolts with tightening torque 125
Nm (12.75 kpm / 92 lbft).
1262 - 004 - 04.06.2020 53
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 535HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 535HX in the language / languages: English as an attachment in your email.

The manual is 13,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info