733796
29
Zoom out
Zoom in
Previous page
1/72
Next page
7. Start the electrical drive. Refer to
To start the
product on page 33
.
8. Put the lever for the hydraulic lifting arms to the
position (B) to lower the lift arms.
A
B
CD
WARNING: Do not put the lever for the
hydraulic lifting arms to the float position
(A). The hydraulic force can cause injury.
9. Turn the power key to the STOP position.
10. Remove the 2 screws and remove the bottom plate.
11. Pull back the rubber casing from the shaft joint.
12. Pull back the couplings of the drive shaft and remove
the drive shaft from the PTO shaft on the product.
13. Pull back the couplings of the drive shaft and remove
the drive shaft from the bevel gear shaft of the
cutting deck.
14. Remove the locking chains.
15. Remove the pins (A) and the bolts (B) from the lifting
arms (C) and joints of the cutting deck (D).
a) For the Combi cutting decks:
B
A
B
A
D
C
b) For the R180 cutting deck:
A
A
B
B
C
To put the Roll Over Protection
Structure (ROPS) in position for the
first time
For the transportation of the product from the factory,
the ROPS is folded above the seat.
1. Remove the screws that attaches the ROPS to the
product.
180°
2. Turn the ROPS 180 degrees.
3. Install the ROPS with the screws.
1262 - 004 - 04.06.2020 29
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 535HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 535HX in the language / languages: English as an attachment in your email.

The manual is 13,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info