733796
27
Zoom out
Zoom in
Previous page
1/72
Next page
b) For the R180 cutting deck:
A
A
B
B
7. Remove the 2 screws and remove the bottom plate.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the PTO shaft on the product.
Note: Make sure that the arrow on the symbol points
to the product.
9. Put the rear locking chain around the lifting beam.
10. Attach the locking chain to the drive shaft.
11. Pull back the coupling of the drive shaft and attach
the drive shaft to the bevel gear shaft of the cutting
deck.
12. Fold the rubber casing onto the shaft joint.
13. Put the front locking chain around the cross pipe.
14. Attach the front locking chain to the drive shaft.
15. Attach the bottom plate and tighten the screws.
16. Start the electrical drive. Refer to
To start the
product on page 33
.
17. Move the lever for the hydraulic lifting arms rearward
to lift the cutting deck. Lift until the pivot wheels of
the cutting deck do not touch the ground.
18. Apply the parking brake.
19. Turn the power key to the STOP position.
20. Attach the lifting eyelets.
a) For the Combi cutting deck: Pull the spring (A)
and attach the lifting eyelets to the cutting deck
(B).
A
B
1262 - 004 - 04.06.2020 27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna P 535HX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna P 535HX in the language / languages: English as an attachment in your email.

The manual is 13,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info