610254

Husqvarna Huskylock 90 Manual

24
Zoom out
Zoom in
Previous page
1/36
Next page
Huskylock 9024
Rolled hemming
When sewing rolled hemming, the loops
formed by the upper looper thread,
should be pulled to the underside of the
fabric. This is done by setting the tensions
as shown on page 17.
Back
Front
Narrow hemming
For seams on sheer or lightweight fabrics.
Set the tensions as shown on page 17 for
a balanced tension.
To carry out either of the above sewing tasks, please proceed as follows.
1) Refer to page 23 "Convertibel presser foot".
2) Turn the handwheel toward you until the needles are fully raised.
3) Open the front cover and remove the left needle. See page 22.
4) Set the stitch length between 1.0-2.0 mm. See page 20. Also ensure that differential
feed is set at the "N" position. See page 26.
5) Adjust the stitch width as shown on page 21.
6) If not already threaded, re-thread the machine.
7) Place the fabric under the presser foot and start to sew.
Always test the stitch and the tension setting on a spare fabric before sewing on your
actual garment.
When sewing either Rolled or Narrow hemming we recommend that you change the
threads as shown on page 17.
Always remember to re-set the special foot adjuster after you have finished your hemming
procedures.
Rolled and narrow hemming
Needle thread
Upper looper thread
Lower looper
thread
1,5 mm
1,5 mm
Needle thread
Back
Front
Lower looper thread
Upper looper thread
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Huskylock 90 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Huskylock 90 in the language / languages: English, Spanish as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info