518052
42
Zoom out
Zoom in
Previous page
1/64
Next page
~ 40 ~
3
1
GETTING STARTED
EMBROIDERING
1. ATTACH THE EMBROIDERY FOOT
Raise presser foot lifter. Turn hand wheel toward you
until needle is in its highest position.
Remove presser foot screw, presser foot and foot holder.
Attach the embroidery presser foot behind presser foot
bar so that the drive lever is above the needle clamp.
Secure it by tightening presser foot screw.
Turn hand wheel toward you to move needle up and
down, and check that the embroidery presser foot moves
up and down together with the needle.
2. THREAD YOUR MACHINE
see page 11-15.
Thread your machine with top thread in the À rst color to be
used in the embroidery.
Note: It is recommended to thread the upper thread before transmitting
a design to the machine for embroidery.
A large amount of thread is required for embroidering, so
be sure to use full bobbin.
Tip: Wind more than one bobbin of embroidery bobbin thread before
starting to embroider, if embroidering several or very large designs.
This will save you time when you run out of bobbin thread.
3. REMOVE THE ACCESSORY BOX
Turn off power to machine. Slide the accessory box to the
left to remove it from machine
(see page 10).
CAUTION
Always be sure to turn off power to machine before
changing presser foot.
Presser foot
Screw
Foot holder
Presser foot bar
Embroidery presser foot
Needle
clamp
Drive lever
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna H Class 600E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna H Class 600E in the language / languages: English as an attachment in your email.

The manual is 3,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna H Class 600E

Husqvarna H Class 600E User Manual - German - 64 pages

Husqvarna H Class 600E User Manual - French - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info