685908
40
Zoom out
Zoom in
Previous page
1/52
Next page
40 hunter.direct/ACC2help
SET UP FLOW MANAGER
Flow Manager runs simultaneous stations to reach a
programmable ow rate target. It allows the controller to
decide which stations to run, to keep total ow as close to
the pipe design capacity as possible, and shorten the overall
watering time.
Flow Manager does not require a ow sensor, but it must have
station ow values to work with. If ow learning via a sensor is
not available, approximate values may be entered manually.
Flow Manager does require one or more Flow Zones, and
requires stations to be attached to the Flow Zones in order to
function. Flow Manager and Flow Monitor can also work at the
same time, and use much of the same information in dierent
ways.
Flow Manager requires the following information to operate
correctly:
Set up Flow Zones and set Flow Targets (Flow menu, Flow
Zones)
Attach stations to Flow Zones (Stations, Station Setup)
Learn or enter station ow rates (Stations, Station Setup)
Set Controller Program Limits, (Stations, Station Limits
menu), if desired.
FLOW ZONES
Dial to the Flow menu and select Flow Zones if they have not
already been created. The Flow Zone denes a section of
pipe and a group of stations attached to that pipe, which is
managed as a hydraulic unit.
For Flow Manager, it is only necessary to Enable Flow
Management and set the Flow Target. Check the box for
Manage Flow.
FLOW TARGET
The Flow Target box is used to set the ow rate desired for the
Flow Zone throughout irrigation. Enter the desired rate of ow
that is best for the mainline pipe diameter (recommended at
5 feet per second or 1.5 meters per second) or a preference
based on other factors.
This is the only setting necessary at the Flow Zone menu
for the Flow Manager function. Flow Manager will try to run
enough simultaneous stations to stay at or near this rate of
ow whenever there are programs available to run.
Flow Operations
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hunter ACC-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hunter ACC-2 in the language / languages: English as an attachment in your email.

The manual is 2,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hunter ACC-2

Hunter ACC-2 Quick start guide - German - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info