624653
36
Zoom out
Zoom in
Previous page
1/48
Next page
Page 33
Spa Care and Maintenance
COVER LIFTER SYSTEM
Clearance required behind cover when open:
CoverCradle
®
& CoverCradle II
24”
UpRite
®
7”
Lift ’n Glide
®
14”
HOW TO OPEN THE VINYL COVER
IMPORTANT: Never attempt to open or remove the vinyl cover by
grasping or pulling on the skirting or cover lock straps. The skirting will
tear, and torn skirting is not covered under the terms of the warranty.
Check for ice build-up around the gas springs and pivot points of the
retractable cover system. Ice buildup may damage system components.
WARNING: The vinyl cover and retractable cover system a
re not
recommended for use in wind conditions reaching above 25 mph (40 kmh).
IMPORTANT: If your spa is located in an area susceptible to high winds,
additional coverlock straps may be installed to minimize wind damage to
the cover.
1. With the cover lock straps unfastened, place one hand under the cover
skirting, between the spa and cover, to break the cover’s vacuum seal.
Then, fold the front half of the cover over onto the back half.
2. If no rear access is available, stand to the side of the spa directly
adjacent to the hinge area of the folded cover.
a) For the CoverCradle retractable cover systems: Using both
hands, cup one hand under the lower half of the cover (just above
the water) and place the other along the side of the cover, just
above the skirt. Gently push (do not lift) with both hands towards the
opposite rear corner of the cover (diagonally). As the cover opens,
the gas springs will allow the cover to come to a gentle stop.
b) For the UpRite
retractable cover system: Simply lift the cover at
its center hinge, allowing it to move to the back of the spa and to rest
gently there.
c) For the Lift ’n Glide
retractable cover system: Slightly lift the
cover at front of spa, glide (push back until it stops), fold cover in half
and lift cover moving it to the back of the spa. Insert locking pin into
side of lifter to prevent accidental closure.
IMPORTANT: When opening a cover with a retractable cover system,
only use one of these three specific methods. Do not attempt to open the
cover in any other way. Damage caused by improper opening or closing
of the cover is not covered under the terms of the limited warranty.
HOW TO CLOSE THE COVER
1. Standing along side the cover, place one hand on the upper corner of
the cover and gently push forward in the direction of the spa. The cover
will rotate forward to cover half of the spa.
IMPORTANT: For the UpRite or Lift ’n Glide retractable cover system,
disengage the locking mechanism(s) before pushing the cover forward.
2. Unfold the cover by lifting the handle located on the top (front) half of
the cover. Allow the unfolded half to fall down onto the spa. The air
pressure created by the cover falling will keep the vinyl skirting from
being trapped between the cover and the spa shell.
36


Need help? Post your question in this forum.

Forumrules
1

Forum

hot-spring-prodigy---h

Reset search

  • I have a 2001 prodigy and the circulation pump doesn’t seem to come on. And now cold weather the jets poor out very cold water. What could this be? Submitted on 18-10-2022 at 15:54

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hot Spring PRODIGY - H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hot Spring PRODIGY - H in the language / languages: English as an attachment in your email.

The manual is 6,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info