720161
77
Zoom out
Zoom in
Previous page
1/112
Next page
75
7 TROUBLESHOOTING
Messages
Messages
If any of the following messages appear in the display, use this troubleshooting guide to address the
problem before contacting your dealer. If the problem persists, contact your dealer.
Message Cause Solution
Area signal lost
The lawnmower does not detect the
boundary wire signal.
Check if the boundary wire connectors are
correctly connected. If the message does not
disappear, contact your dealer.
Battery capacity
low
The battery does not charge enough.
Increase the remaining capacity of homing. See
“Homing setup” (M page 48). If the message does
not disappear, contact your dealer.
Battery capacity
reduced
The battery does not charge enough.
Battery temp
high
The battery temperature is too high. Set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Battery temp low (1)
Battery temp low (2)
The battery temperature is too low. Put the lawnmower in a place where the
temperature 5°C or higher, set the power to ON,
and wait until the message disappears.
If the message does not disappear, contact your
dealer.
Battery voltage
high
The battery charges too much. Remove the lawnmower from the docking station,
set the power to ON, and wait until the message
disappears.
If the message does not disappear, contact your
dealer.
Battery voltage
low
The battery does not charge enough. Charge the lawnmower with the docking station.
This message disappears if the battery is charged
more than 10%.
If the message does not disappear, contact your
dealer.
Blade motor
temp high
The temperature of the blade motor is
or exceeds 85°C.
Leave the power ON and the control panel cover
open, and wait 15 to 30 minutes until the message
disappears. If the message does not disappear,
contact your dealer.
Clock reset
The backup battery power has drained
during long-term storage. The clock
has been reset.
Set the current date and time. The time must be in
24-hour format.
If the clock cannot be set, contact your dealer.
ENT key
The Enter button was pressed while
the lawnmower was running (with the
control panel cover closed).
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Excessive tilt
The lawnmower is in an excessively
tilted area.
Place the lawnmower on a at surface, and enter
the PIN so that the message disappears. If the
message does not disappear, contact your dealer.
Key pad
A button was pressed while the
lawnmower was running (with the
control panel cover closed).
Open the control panel cover and check if any
foreign objects are stuck inside.
If this message appears after removing any
foreign objects, contact your dealer.
Mower lifted
The cover has been lifted by
something, e.g. a stone.
Enter the PIN so that the message disappears.
If the cover is heavily damaged or the message
does not disappear, contact your dealer.
Cutting height
error
The height of the blade disc is off.
Refer to "Setting the height of the blades" (M page
70) and perform [Calibrate].
If the message does not disappear, contact your
dealer.
77


Need help? Post your question in this forum.

Forumrules
1

Forum

honda-miimo-hrm3000

Reset search

  • How do I reset the password if I have forgotten it? Submitted on 11-3-2023 at 14:51

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Miimo HRM3000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Miimo HRM3000 in the language / languages: English as an attachment in your email.

The manual is 36,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Miimo HRM3000

Honda Miimo HRM3000 User Manual - German - 108 pages

Honda Miimo HRM3000 User Manual - Dutch - 108 pages

Honda Miimo HRM3000 User Manual - French - 108 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info