568887

Hitachi NR90GC2 Manual

9
Zoom out
Zoom in
Previous page
1/90
Next page
English
8
⅜ Keep the firing head down.
Strictly observe the above instructions, and always
make sure that no part of the body, hands or
legs is ever in front of the nail outlet.
12. Do not carelessly place your finger on the trigger.
Do not place your finger on the trigger except when
actually nailing. If you carry this tool or hand it to
someone while having your finger on the trigger,
you may inadvertently discharge a nail and thus
cause an accident.
13. Press the nail outlet firmly against the material to
be nailed.
When driving in nails, press the nail outlet firmly
against the material to be nailed. If the outlet is not
applied properly, the nails may rebound.
14. Keep hands and feet away from the firing head
when using.
It is very dangerous for a nail to hit
the hands or feet by mistake.
15. Do not touch around the exhaust outlet.
This tool produces hot exhaust gases
that may flammable materials. The
push lever and nose will become hot
and get heated up after prolonged or
rapid use.
Do not touch with bare hands.
16. Beware of the tool’s kickback.
Do not approach the top of the tool with your head
etc. during operation. This is dangerous because the
tool may recoil violently if the nail currently being
driven in comes into contact with a previous nail or
a knot in the wood.
17. Take care when nailing thin boards or the corners
of wood.
When nailing thin boards, the nails may pass right
through, as may also be the case when nailing the
corners of wood due to deviation of the nails. In such
cases, always make sure that there is no one (and
nobody’s hands or feet; etc.) behind the thin board
or next to the wood you are going to nail.
18. Simultaneous nailing on both sides of the same wall
is dangerous.
Under no circumstances should nailing be
performed on both sides of a wall at the same time.
This would be very dangerous since the nails might
pass through the wall and thus cause injuries.
19. Do not use the power tool on scaffoldings, ladders.
The power tool shall not be used for specific
application for example:
– when changing one driving location to another
involves the use of scaffoldings, stairs, ladders or
ladder alike constructions, e.g. roof laths,
– closing boxes or crates,
– fitting transportation safety systems e.g. on
vehicles and wagons
20. Disconnect the battery and fuel cell and take out
any nails left in the magazine after use.
Disconnect the battery and fuel cell from the tool
before doing tool maintenance, cleaning a jammed
fastener, leaving work area, moving tool to another
location, or after use. It is very dangerous for a nail
to be fired by mistake.
21. When removing a nail which has become stuck,
make sure to first of all disconnect the battery and
fuel cell.
When removing a nail which has become stuck in
the nail outlet, first of all make sure to disconnect
the battery and fuel cell inside the power tool.
Accidental firing of the nail could be very dangerous.
22.
The operating environment for this device is
between 0°C (32°F) and 40°C (104°F) so ensure use
within this temperature range. The device may fail
to operate below 0°C (32°F) or above 40°C (104°F) .
23. Always charge the battery at an ambient
temperature of 0–40°C.
A temperature of less than 0°C will result in over
charging which is dangerous. The battery cannot
be charged at a temperature greater than 40°C.
The most suitable temperature for charging is that
of 20–25°C.
24. Do not use the charger continuously.
When one charging is completed, leave the charger for
about 15 minutes before the next charging of battery.
25. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
26. Never disassemble the rechargeable battery or
charger.
27. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause
a great electric current and overheat.
It results in burn or damage to the
battery.
28. Do not dispose of the battery in fire.
If the battery is burnt, it may explode.
29. Using an exhausted battery will damage the
charger.
30. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use.
Do not dispose of the exhausted battery.
31. Do not insert objects into the air ventilation slots
of the charger.
Inserting metal objects or flammable into the
charger air ventilation slots will result in an electrical
shock hazard or damage to the charger.
32. Do not inhale its contents.
In case of being inhaled ; the person
affected should be taken into the
open air and brought into a
comfortable position.
33. Expanding gases cause low temperatures.
Fluid gases might cause injuries when getting in
touch with skin or eyes.
– In case of contact with skin; wash the contact
surface carefully with warm water and soap and
apply a skin cream when dry.
– In case of contact with eyes; rinse the open eyes
under running water.
Contact a doctor if necessary.
34. Fuel cells.
Store in well–ventilated area.
Do not store above 50°C (120°F)
(e.g. direct sunlight or in a vehicle).
Do not expose to an open flame
and sparks.
Do not puncture or open the fuel cell.
Do not refill, reclaim or recycle the fuel cell.
Dispose of according to local regulations for aerosol
products.
MAX 50°C
(120°F)
01Eng_NR90GC2_WE_7L 4/14/08, 8:11 PM8
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi NR90GC2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi NR90GC2 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info