565926

Hitachi CM14E Manual

13
Zoom out
Zoom in
Previous page
1/232
Next page
13
GB
Facts About Abrasive Wheel
Always read the label on the wheel. If the wheel does not cut well, it may be
the wrong type for the material. Forcing it to cut may result in shattering of
the wheel and serious injury to the operator.
WARNING
Do not grind with a cut-off wheel or put pressure on the sides.
Use only HITACHI reinforced wheels, or wheels approved for
this cutter by HITACHI. Wheels that are too thick or fi t the arbor
improperly may shatter, causing serious personal injury. So may
wheels of low speed rating or those that are cracked, wrapped, out-
of-round or edge-damaged.
A wheel can stand a lot of cutting pressure as long as the pressure is
straight on and not from the side of the wheel. This is why you always must
make only straight line cuts, by avoiding cutter tilt or wobbling off line during
a cut.
Cutters intended for forcible entry should be equipped with new wheels for
each use. If the used wheels can pass the ring test (page 12) and close
inspection, they may be use in training emergency crews.
Put no Side
Pressure on
the Wheel
Check every wheel for warping, cracks and broken edges before mounting
on the cutter.
Warped wheels do not cut properly and may be stressed to the point of
breaking. Always store your wheels sown fl at on a smooth, fl at and dry
surface. When stacking many wheels, place cardboard or paper spacers
between them as a cushion.
Moisture and heat both can cause wheel damage. Do not let wheels lie
in the sun or expose them to high heat. Keep wheels dry at all times, and
store in an area of low humidity and moderate temperature. Protection from
moisture damage applies during water-fl ush cutting. To keep water from
penetrating the wheel, bring wheel up to cutting speed before turning on
water, and maintain wheel rotation for 10 seconds after shutting off water.
Handling and Storage of Wheels
CM14E_WE_all.indb 13CM14E_WE_all.indb 13 2008/02/05 21:09:312008/02/05 21:09:31
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hitachi CM14E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hitachi CM14E in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 9,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info