168839
15
Zoom out
Zoom in
Previous page
1/20
Next page
Speaker & RCA Connections
TXi 1700
FULL-MODE / Connection of a Loudspeakersystem
• Connect the "LINE IN" of the amplifier to the head unit´s line output with appropriate good quality RCA cables.
• Connect the speakers with appropriate wires to the terminal block (SPEAKER OUTPUT - and +) of the amplifier.
• The minimum final speaker impedance must not be lower than 1 Ohms in total. Too low speaker loads result in too high heat dissipation and may
cause the amplifier run into protection.
• Please observe correct speaker channels and polarity as printed by the speaker terminal.
• Caution: The loudspeakers don´t get a stereo-signal. If you want to get a stereo-signal you have to use a second amplifier in
Master/Slave-Mode.
• If your head unit has an subwoofer line output with an integrated crossover you are able to use one or two subwoofers in Full-Mode.
In this mode PHASE - Control, LOW PASS - Control, SUB SONIC - Control and BASS REMOTE are out of function.
MODE - Switch
• Set the switch in this operation mode to "FULL" - position.
FREQ RANGE - Control
• Allows you to adjust the frequency at which the bass boost should work. It is continously variable between 20Hz up to 80Hz.
Q-Control
• Allows you to adjust the filter performance Q of the crossover. So you can change the playback quality in the range of the cut-off
frequency."WIDE" Q - 0.3, "NARROW" Q - 1.0. Regular setting is on 12 o`clock - position Q - 0.5/Linkwitz-Reilly and
3 o`clock - position Q - 0.7 /Butterworth.
SUB BOOST - Control
Allows you to adjust the bass boost from 0dB up to 18dB.
LEVEL
• Turn the LEVEL control of the amplifier to 6V position.
• Turn the head unit volume control to about 80 - 90% of its full setting.
• Turn the LEVEL control clockwise until you hear some distortion.
• Then turn back the LEVEL control slightly until you can hear a clean sound.
In this example the Bass-Remote-Control can not be used!
By using a additional subwoofer,
connect it to the non-occupied
terminals, ensure that the total
impedance load is not lower
than 1 Ohm.
Caution!
Do not connect speaker (-) to the ground or vehicle's chassis.
+
+
Mono Speakers 2 - 8 Ohm
Connect RCA outputs of the head unit with
LINE IN of the amplifier.
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hifonics txi 1700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hifonics txi 1700 in the language / languages: English, German as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info