Manual Hendi 230442 (page 14 of 144) (English, German, Dutch, French, Italian, Polish)

742508

Zoom out

Zoom in

1/144

Injector cleaning

If the device is penetrated by impurities as sand,

small pebbles or other deposits, they may block

the injector (an element of the softener responsi-

ble for sucking brine). If the softener is protected

with a sedimentation pre-ﬁlter, whereas the salt is

of good quality, the injector should not clog.

If, however, it is clogged, it shall be cleaned. Fig. E

shows a diagram of the injector. The elements most

vulnerable to clogging are marked with numbers

12 and 14. In order to clean the injector, water inlet

to the device shall be shut off. Successively, cold

water tap shall be opened to release pressure from

the system. Mounting bolts shall be unscrewed

(the location thereof is marked with number 16)

with a screwdriver. The injector shall then be dis-

connected from the control head. Mind the seals.

Elements 12 and 14 may be unscrewed gently with

a screwdriver. All parts can be cleaned with water

and then blown through. After drying, they shall be

assembled again and the injector can be installed

in a manner reverse to the instructions above.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 230442 in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 1,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hendi 230442 Manual

Product: