741203

Hendi 226094 Manual

8
Zoom out
Zoom in
Previous page
1/40
Next page
CHECKING THE PRESSURE
The distribution network pressure must meet the following specifications.
LPG
ALLOWED from 20/25 to 35/45 mbar
NOT ALLOWED below 20/25 above 35/40 mbar
METHANE - H
ALLOWED from 17 to 25 mbar
NOT ALLOWED below 17 above 25 mbar
If the gas distribution network pressure on the installation site doesn't meet the above values, inform the gas board and do not
turn the unit on until the cause and a solution have been found. The distribution network pressure can be taken with a U
manometer (min. definition 0.1 mbar), connected to the pressure outlet behind control panel fig.8.
1. Remove the control panel.
2. Remove the screw and sealing washer from the pressure outlet and connect the manometer.
3. Turn the unit on following the enclosed instructions and check that the pressure is within the permitted pressure range.
4. Disconnect the manometer and replace the screw and the sealing washer in the pressure outlet.
5. Replace the control panel.
ELECTRICAL CONNECTION
Before proceeding with the electrical connection, check the specifications on the data plate.
The appliance is supplied with a power cable (3x1,5 H07RN-F).
The installer must make the connection after having installed a standard plug connected to an easy-to-reach socket, or in case
of a permanent connection, after having installed a main switch, which, as well as being easy to reach, must disconnect all of
the contacts supplying electrical energy to the appliance, with a minimum distance of at least 3mm between the poles. The earth
wire must never be disconnected.
The power cable must not be installed near heat sources and the temperature of the place in which the appliance is installed
must not rise above 50°C. The appliance must also be connected to an equipotential earth. This connection can be made using
the equipotential terminal marked with the symbol , placed under the appliance near the right rear foot. The equipotential wire
must have a section of 10mm
2
.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hendi 226094 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hendi 226094 in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 4,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info