725536

Haus Luft HL-OS-20 Manual

17
Zoom out
Zoom in
Previous page
1/44
Next page
17
GB
BEFORE FIRST USE
1. Unpack the dehumidifier, remove all plastic bags, inserts and safety locks and closures. If the
appliance has been in a position other than vertical, wait at least 24 hours before switching
it on.
2. Verify that your power mains match the nameplate ratings of the dehumidifier.
3. Install the carbon filter (14) in the pre-filter (12) (see: “CLEANING AND MAINTENANCE”).
4. Check if the water tank (9) has been installed properly (see: “EMPTYING THE WATER TANK”).
5. The first use should be as long as possible, preferably 24 hours.
USE OF THE APPLIANCE
1. Place the appliance on a level, stable and smooth sur-
face. Maintain at least 20 cm of empty space on each
side of the appliance to ensure free air circulation (Fig.
1).
2. Close the windows in the room in which the appliance
is intended to run. The dehumidifier will not be able to
decrease humidity otherwise. Ongoing air exchange
might have a negative effect on the expected results.
If you want to dehumidify the air in the entire house,
open the doors between the rooms and remember to
close all windows.
WARNING! The device is recommended for rooms with an area of 20-30 m
2
.
3. Plug the dehumidifier in.
4. Turn the dehumidifier on by pressing the switch (2a) – the indicator light (2i) will light up,
indicating operation, the display (2t) will show the current RH level and the fan will start up.
CAUTION! Do not move the appliance during operation.
5. Press the mode button (2b) to choose dehumidifying (SMART) – the indicator light will light
up (2r). In this mode, the dehumidifier will try to maintain humidity at 55%. The humidity
level is shown on the display (2t).
CAUTION! The dehumidifier is only used to lower the relative humidity. The dehumidifier is not able to humi-
dify the air.
6. To set a different humidity level, push the button (2b) to select LOW or HIGH fan speed. Only
these two modes allow humidity levels different than 55%. Set a target humidity level by
pressing the humidity/time navigation buttons (2c, 2d). The selected level will pulse for a
moment and the display will show the current RH level again. It may be set from 35 to 80% at
5% steps. The appliance will operate until the selected level is reached, then compressor turn
off and turn back on when humidity increases. The dehumidifier fan will work all the time.
The LOW mode decreases the fan speed to the absolute minimum, while in the HIGH mode
the dehumidifier will reach the selected humidity as quickly as possible.
CAUTION! To ensure efficient operation, the controller allows the operation to be interrupted below the select-
ed level and resumed above the selected level (up to 3%) with a delay .
20cm
20cm
Fig. 1
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haus Luft HL-OS-20 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haus Luft HL-OS-20 in the language / languages: English, German, Polish as an attachment in your email.

The manual is 3,94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info