624012

Hartke HA2500 Manual

11
Zoom out
Zoom in
Previous page
1/20
Next page
9
Setting Up and Using The Model 2500
Model 2500 Effect Send/Return jacks
7. Experiment with altering the balance of the two Pre-Amp knobs, listening to
the effect each has on the overall sound. Depending upon the specific instru
-
ment you are using and your personal taste, you may prefer the sound of one
over the other, or you may prefer a particular blend of the two. Note that, when
both are used at equal settings, the amplifier will be twice as loud as when only
one is used. In step #4 on the previous page, we recommended that you begin
with both knobs at their midway “5” setting, but the two Pre-Amp knobs can in
fact be set to any blend you like. However, you will usually want to avoid setting
both to their maximum “10” position since this setting will almost always result in
undesirable distortion.
8. When you have settled on a Pre-Amp balance, the next step is to adjust the
two Contour (bass and treble equalizer) controls to taste. For more information,
see the “About Equalization” section on page 10 of this manual. When you get
a great setting that complements your instrument and playing style, it’s a good
idea to write it down for future use.
9. Next, experiment with the Model 2500 graphic equalizer. Begin by setting
each of the ten sliders to their flat “0” center detented position. Then press in
the In/Out switch (to its “In” position) so that the graphic equalizer is activated.
Finally, move each slider in turn as you play your bass. For more information, see
the “About Equalization” section on page 10 of this manual. Again, when you get
a graphic equalization setting that complements your instrument and playing
style, it’s a good idea to write it down for future use.
10. Now try out the Model 2500 compression circuitry. Activate it by turning
the Compression knob clockwise from its “Off” position (you’ll hear a click when
it is activated). As you turn the knob clockwise, the input signal from your bass
becomes more and more severely compressed—you’ll hear peak signals (such
as string slaps and pulls) begin to sound increasingly “squashed,” relative to the
lower-level signals produced by standard playing. The result will be a decreased
dynamic range but an overall leveling of signal throughout the full pitch range of
your instrument. For more information, see the “About Compression” section on
page 12.
11. If you’re using an external signal processor, turn your Hartke amplifier off
momentarily and then connect a standard audio cable between the Effect Send
jack and your effects processor input and another standard audio cable between
the Effect Return jack and your effects processor output (if required, multiple
effects processors can be daisy-chained together, output to input). Then turn the
amp back on and play your bass while adjusting the controls of your outboard
effects processor(s). For best results, set both the input and output gain of all
connected effects processor(s) to 0 dB (unity gain), so that there is no increase or
decrease in level whether the effects are switched in or out.
If you have followed all the steps above and are still experiencing difficulties, call
Samson Technical Support (516-932-1062) between 9 AM and 5 PM EST.
5
4
3
2
1
0
6
7
8
9
10
5
4
3
2
1
0
6
7
8
9
10
A B
TUBE SOLID STATE
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hartke HA2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hartke HA2500 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info