624012
13
Zoom out
Zoom in
Previous page
1/20
Next page
11
About Equalization
To find out how each graphic equalizer slider affects the sound of your par-
ticular bass, start with all ten bands flat (that is, all ten sliders at their detent
-
ed “0” center position). Then, one by one, raise and lower each slider, lis
-
tening carefully to the effect of each. If you don’t specifically need to utilize
the ten-band graphic equalizer, bypass it by setting the In/Out switch to its
“Out” position. Alternatively, you can preset a custom graphic equalization
curve (for example, for a feature solo) and activate it simply by pressing the
switch when needed. Note that turning all EQ controls up the same amount
will have virtually the same effect as simply turning up the Master Volume;
conversely, turning them all down the same amount will have virtually
the same effect as turning down the Master Volume. Both approaches are
pointless (after all, that’s why we gave you a Master Volume control!)
In many instances, the best way to deal with equalization is to think in terms
of which frequency areas you need to attenuate, as opposed to which ones
you need to boost. Be aware that boosting a frequency area also has the
effect of boosting the overall signal; specifically, too much low frequency
EQ boost can actually cause overload distortion or even harm a connected
speaker, though the Model 2500’s compression circuitry—if on—will act
to some extent to prevent this from occurring. In general, if you’re going
to apply a fair amount of low frequency EQ boost, its a good idea to keep
Compression on, if only to protect your speakers from potential damage.
The specific EQ you will apply to your bass signal is very much dependent
upon your particular instrument and personal taste and playing style.
However, here are a few general suggestions:
For that super-deep reggae or Motown sound, boost low frequen
-
cies slightly while attenuating the highest ones (leave mid-range
frequencies flat or slightly attenuated), as shown in the illustration
on the right.
To remove boxiness and make your instrument sound more hi-fi,
try attenuating mid-range frequencies while leaving low and high
frequency settings flat, as shown in the illustration on the right.
For a twangy, cutting sound, try boosting the high and high mid-
range frequencies, as shown in the illustration on the right (putting
new roundwound strings on your bass will help a lot also!)
Whenever you get a really good EQ setting for a particular instru
-
ment or song, write it down (you’d be amazed how easy it is to for
-
get these things!).
Finally, as you experiment with the EQ controls of the Model 2500, don’t
forget that your bass also provides EQ controls in the form of its tonal set
-
tings—this can be particularly effective in instruments that have active
circuitry. Also, try various EQ settings with different Pre-Amp blends and
with and without Compression. For more information, see the About
Compression section on the following page.
IN
OUT
+15
+1
2
+9
+6
+3
+2
-2
-3
-6
-9
-12
-15
+15
0
-15
8KH
z
5KHz3KHz2KHz1KHz500Hz250Hz125Hz64Hz30Hz
8KHz
5KHz3KHz2KHz1KHz
500Hz250Hz125Hz64Hz30Hz
IN
OUT
+15
+1
2
+9
+6
+3
+2
-2
-3
-6
-9
-12
-15
+15
0
-15
8KH
z
5KHz3KHz2KH
z1KHz500Hz250Hz125Hz64Hz30Hz
8KH
z
5KHz3KHz2KHz1KHz
500Hz250Hz125Hz64Hz30Hz
IN
OUT
+15
+1
2
+9
+6
+3
+2
-2
-3
-6
-9
-12
-15
+15
0
-15
8KHz
5KHz3KHz2KHz1KH
z500Hz250Hz125Hz64Hz30Hz
8KH
z
5KH
z3KHz2KHz1KHz500Hz250Hz125Hz64Hz30Hz
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hartke HA2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hartke HA2500 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info