683782

Hako Scrubmaster B140R Manual

6
Zoom out
Zoom in
Previous page
1/38
Next page
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Method of operation
of Hakomatic B 910
A squeegee and suitable brushes or
pads are required for wet cleaning of
hard floorings.
The rotating brushes scrub the floor
thoroughly, removing the dirt by
means of suds, thus cleaning the
floor. The soiled water is drawn in
during the same cycle by means of
the squeegee. This way the floor can
be stepped on immediately after-
wards; it is dry and clean.
Useful advice for perfect work
Prior to wet cleaning it is necessary to
sweep the floor. The Hakomatic B 910
carries out this work if equipped with
the optional pre-sweeper (accesso-
ries).This way, not only the cleaning
efficiency is improved, but wear of the
machine will be substantially reduced
at the same time.
If floors are particularly dirty or if wax
has to be removed (basic cleaning),
the floor should be treated twice.
During the first cycle, the floor is
scrubbed with a cleaning agent
se.lected according to the degree of
dirt encountered, the vacuum system
remaining turned off and the squee-
gee remaining lifted.
Allow the cleaning agent to act on the
floor for approx. 5 or 10 minutes, com-
plying with the manufacturer’s instruc-
tions, then scrub the floor once again
while the vacuum system is turned on
and the squeegee is lowered.
How to take the
machine into operation
Assembly
When being supplied to you, the
Hakomatic is packed in a cardboard
box. The floor consists of a wooden
platform where the machine is fixed
by means of plastic straps.
Open the box from its bottom side
and remove it by pulling upwards.
After detaching the plastic straps, you
now can take the machine from the
platform
Installation of brushes
Refer to paragraph ”Installation/Re-
moval of brushes” on page 54.
Installation of squeegee
Refer to paragraph ”Installation of
squeegee” on page 56.
Note: For ease of compliance with the
appropriate safety regulations, we re-
commend to use the above-mentioned
batteries. Batteries and charger units
are matched; therefore only use the
batteries and charger units specified
by us in order to comply with the pro-
visions for safety.
We can grant full warranty only if those
units are used.
Whenever working on the electrical
system, disconnect the battery plug.
The seat hood has to be opened
during the charging procedure to pre-
clude formation of an ignitable gas
mixture (oxyhydrogen).
38
Scrubmaster B140 R
The Scrubmaster B140 R
Scrubmaster is packed in a cardboard
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hako Scrubmaster B140R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hako Scrubmaster B140R in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info