564793
4
Zoom out
Zoom in
Previous page
1/19
Next page
4
Please read through these operating instructions carefully. You will be informed about the function and handling of
this stove and you will also save fuel and conserve the environment by heating correctly.
The attached equipment sheet is part of these operating instructions.
1. General information
Please check the appliance for transport damage when unpacking it. In case of defects, please report
these immediately to your stove dealer!
National and European standards, local regulations and those under building law as well as the relevant
state building regulations or fire regulations must be complied with when installing, connecting and putting
the fireplace into operation.
The pellet stove described in these instructions has been tested according to DIN EN14785 and
according to the electrical standard, DIN EN 60335-2-102.
2. General safety information
The combustion of fuels releases heat energy, which leads to the surfaces of the heating appliance (e.g.
doors, inspection window panes, side walls, front wall, flue tube) heating up significantly.
The appliance starts independently in "Standby mode". Due to the build-up of heat on the window pane,
care should be taken that no unsupervised persons, who do not know how to operate the pellet stove, are
in the installation room.
Air extraction equipment such as ventilation systems, extractor hoods, vented tumble dryers etc. or other
fireplaces must not have a disruptive influence on the air supply for the stove.
During operation, the combustion air opening provided must not be closed, throttled, constricted, covered
or shut off.
On stoves with an outdoor air connection, the opening must not be shut or closed during operation.
Make children aware of these dangers and keep them away from the fireplace when it is in heating mode.
The combustion chamber door must only be opened for cleaning and maintenance purposes when in
“Off” mode. Otherwise this should always be kept closed.
The pellet stove may only be connected to the mains after being properly connected to the fireplace.
The protective grille in the pellet container must not be removed.
The pellet stove must only be operated when the tank cap is closed.
Never use liquid fuels to ignite the pellet stove or to revive existing embers.
Do not place any laundry items on the stove to dry!
When operating your heating appliance, it is forbidden to work with highly combustible and explosive
materials in the same or adjoining rooms!
The stove must not be set up to be operated jointly with the home’s air conditioning and ventilation units.
Exceptions:
RLU certified appliances can also be operated with extractor hoods, vented tumble dryers and air conditioning and
ventilation units if the stove has also been connected to a balanced flue.
3. Electrical connection
The stove is operated with a mains voltage of 230V 50Hz. The average power consumption is 50-60
Watts. During the ignition phase, the power consumption can increase to 400 Watts.
Only use the original mains cable supplied with the appliance
The socket must be easily accessible.
4. Chimney
The chimney should be made e.g. of stainless steel or ceramic (glazed inside) so that it cannot become
contaminated from soot and damp. This is necessary due to the low flue gas temperature of your pellet stove.
Please observe the national regulations.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Haas-Sohn PELLETTO-RLU 418.08 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Haas-Sohn PELLETTO-RLU 418.08 in the language / languages: English as an attachment in your email.

The manual is 0.59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Haas-Sohn PELLETTO-RLU 418.08

Haas-Sohn PELLETTO-RLU 418.08 Usermanual and installation guide - German - 34 pages

Haas-Sohn PELLETTO-RLU 418.08 User Manual - French - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info